Pre-season is the one phase when aerobic fitness should change week to week. One Submaximal Fitness Test (SMFT) a week, inside the warm-up, shows who is adapting. This guide goes week by week: what to do, what to look at and what to decide before the first match.
Before week 1
One SMFT a week, inside the warm-up: a few minutes at one fixed speed. What the numbers mean is explained in How to Test Fitness In-Season Without a Testing Day.
Set the protocol once
Firstbeat Sports Cloud › Reporting › Fitness Testing. Every later test reuses it. Step-by-step in the Help Center.
Pick the slot and keep it
Same day, same point in the warm-up, every week.
Brief the players
Run at the defined, steady speed. Running faster than instructed spoils the result.
Week 1 · Set the baseline
Do
First SMFT, plus one maximal test (30-15 IFT, Yo-Yo or MAS) the same week.
Look
Each player’s starting level. Near 70% HRmax at 12 km/h is fit; near 90% or above is a low starting point.
Decide
Nothing yet. Note who starts low and ask about their off-season.
Weeks 2–3 · Is the work landing?
Do
Same day, same warm-up, same speed.
Look
The squad average should come down. Whose result is flat or rising?
Decide
Flat or rising: check that player’s load and Quick Recovery Test (QRT) from the same week before changing anything.
Team Summary after a test: Peak %HRmax per player and the change from the previous test. Example data.
Weeks 4–5 · Who is following slower?
Look
Curves start to level off. Who is still near their week 1 level? Late joiners and returning players follow their own track.
Decide
Extra conditioning or a lighter load for individuals, based on the trend, not one test.
Final week · Lock the in-season baseline
Do
The last pre-season test, same protocol. This result is the benchmark for the season.
Decide
Who to discuss with the coaching staff before the first match: minutes, extra conditioning, a closer eye in the first weeks.
One result is a data point; the pre-season trend is the signal.
Where the test sits in the week, in pre-season and in season.
Into the season
Test at least every second week. Keep the day and warm-up consistent. MD-4 or MD-3 often work well, but consider the constraints of your own setting.
Reading a result in 60 seconds

After the test, three steps: Team Summary, player trend, check the test was done right.

How much change is real: under 3 points of %HRmax is likely noise, 3–6 points means monitoring the trend, over 6 points means reviewing the plan. The thresholds are somewhat individual.
One player, one pre-season
Example data from the Firstbeat Sports demo account. The same run, test after test.
- −1.6 and −0.4 points: likely noise. Keep going.
- −7.3 points: most likely the conditioning block taking effect.
- +3.6 points as matches start: monitor the trend.
Start small: one test embedded in the routine beats a perfect test battery that happens 1–2 times a year.
Peak %HRmax (60 s) and Heart Rate Recovery (60 s, %) with the player’s own baseline band.
How to do this in practice with the Firstbeat Sports Coach App?
The step-by-step instructions are in the Firstbeat Sports Help Center:
Questions coaches ask us
Does the test cost a training day?
No. A few minutes inside a warm-up you were going to run anyway.
Can a player cheat it?
No. Only wrong pacing spoils a result.
HRex went up after our hardest week. Is the athlete losing fitness?
Probably not. A short-term rise after a hard block is usually fatigue.
Can we use a drill instead of a run?
Yes, if the workload is close to identical every time. A passing drill works; a small-sided game does not.
Want a second pair of eyes on your pre-season testing?
Book a free 30-minute Team Load Review: a Firstbeat sports scientist goes through your weekly rhythm and current monitoring, and you get a one-page summary and reference values for your sport afterwards.
Sources: Firstbeat sports science team; Buchheit et al., Maximizing the submaximal (SPSR #266); Firstbeat Sports demo account.